Wilson Electronics 801102: P

Wilson Cellular Wireless 43 DB Amplifier / Repeater Model #801102 The amplifier / repeater greatly improves signal strength inside a building when using your cellular phone. It does this without a physical connection to your phone, allowing you to walk freely during a call. It even allows multiple phones to be used simultaneously. The signal is received by the outside antenna from the cellsite. It is then amplified and repeated to your phone through the inside antenna. When the phone transmits it is received by the inside antenna. It is then amplified / repeated to the cell site through the outside antenna. FEATURES:

Wireless Operation - No Physical Connection to cellular phone.
Increases signal strength in buildings for AMPS frequencies
Allows multiple phones to be used simultaneously
Safer than using your cellular phone without an amplifier.*
Extends the life of your cellular phone battery.*
significantly increases your cellular phone range on send and receive
Low cost solution with uncompromised performance
FCC Type Accepted
Works on AMPS frequencies 824-894 MHz (Analog and Digital)(CDMA, TDMA & GSM) Only Amplifies 824 to 894 MHz. 1900 MHz Band is unaffected.

* A cellular phone using the Wilson amplifier is safer and will use less battery power because the phone thinks it is much closer to the cell site than it actually is. Phones vary their power output based on their proximity to cell sites. Therefore, your phone transmits less power - resulting in safer use and longer battery life.
SPECIFICATIONS: Frequency..................824-849MHz Uplink Gain.......................43dB uplink Flatness...................+/- 3DB Uplink Max RF Output Power........5dB Uplink Uplink Downlink Isolation..More than 90db Power Consumption..........13.8V, 1.5A Connecter..................FME-Male 50 ohms Dimensions.................5.5 x 4.3 inches Weight.....................1.32 pounds PACKAGE CONTENTS

Bi-Directional Amplifier/Repeater
AC-to-DC transformer

REQUIRED ACCESSORIES (NOT INCLUDED):

Outside Antenna
Inside Antenna
Coax Cable
Lightning Suppressor*

Lightning protection is recommended for all installation. INSTALLATION: Installing the Outside Antenna

Select a location on the roof using your AMPS phone in test mode to find the best signal strength.
The Outside Antenna should be located in an area with at least a 3 ft. radius clear of obstructions and other radiating elements.

WARNING: The outside antenna used with THE Wilson Amplifier must be fixed-mounted on an outdoor permanent structure with a separation of at least 20 feet from all persons during normal operation. Installing the Amplifier /Repeater

Mount the Amplifier/Repeater on a wall or

CLICK HERE FOR MORE DETAILS

Menu

Wilson Electronics 801102: P